Home > Gate Openers > Accessories >

Reflection Photo Cell Infrared Sensor Photo Eye - LM104
Reflection Photo Cell Infrared Sensor Photo Eye - LM104

Alternative Views:

Price: $45.00

Stock Status:Available

Availability: Usually Ships in 24 to 48 Hours
Product Code: LM104B-AP


No need to run the wire all over the gate to another side any more, just simply connect this device to the gate opener! When it comes to keeping your automated gate safe ALEKO Infrared sensor is the way to go. Have peace of mind knowing your family and vehicle will be protected from the occasional mishap that can sometimes occur. One or two carefully placed sensors keeps your automatic gate opener from accidentally closing on a vehicle or person by immediately stopping and reversing. Having this sensor is more reliable and you don't need to worry about changing batteries.


  • The Safety Photocell Infrared Photo Eye Sensor is easy to install on gate openers, driveways and garages
  • Includes (1) photocell, (1) reflector, (1) bracket and (1) set of nuts and bolts
  • Creates an invisible security barrier; stops gate from closing on a vehicle or person by stopping and reversing
  • Easy to install
  • Detection Method: Retro-Reflective; Angle: approximately 1.5 degrees
  • Normally open and closed volt free relay contacts rated up to 1A 250V AC
  • Maximum sensor range: 40 Feet
  • Supply Voltage: 12-36 VDC or 12-24 VAC
  • Sensor dimensions: 1 x 3 x 2 inches
  • Reflector dimensions: 4 inches diameter
  • Protection Degree: IP66

Average Rating: Average Rating: 3.5 of 5 3.5 of 5 Total Reviews: 2 Write a review »

  0 of 0 people found the following review helpful:
3 of 5 AR 1450 need the correct photocell or wiring instr August 12, 2019
Reviewer: Veni Galarza from Miami, FL  
I have an AR 1450 gate opener. I bought the LM104 IR Photocell but the wiring instructions do not show my model. Please tell me how to wire or a different photocell if necessary. Vgalarza@yahoo.com

Was this review helpful to you?

  0 of 1 people found the following review helpful:
4 of 5 August 24, 2018
Reviewer: Joshua Fore from Spokane, WA United States  
Haven't been able to get it to function. I can see that it is aligned and can tell it is functioning by the LED on the unit. But can't get it to communicate with my ac600(s). Not sure if it is compatible with this unit, but never saw a list of units it works with on the website when purchasing. Still working to get it to function

Was this review helpful to you?